BPI Damp-proofing Cream – 1 Litre

Product Description BPI Damp-proofing Cream 1 Litre is a ready-to-use silicone emulsion damp-course injection cream for use in brick, stone and masonry walls to help control rising damp. The cream is applied using a suitable 1 litre DPC applicator gun into a series of 12mm holes drilled into the selected mortar bed. Once injected, the cream is designed to migrate into the masonry and mortar bed, forming a water-repellent barrier within the wall to help control rising damp. BPI Damp-proofing Cream can be applied from either the internal or external face of the wall and is suitable for professional damp proof course installation. Holes should be drilled at intervals of no more than 120mm, with the DPC positioned at least 150mm above external ground level where practicable. BPI Damp-proofing Cream is designed to control rising damp. However, walls may remain damp after DPC installation where they are contaminated with hygroscopic salts. Salt-contaminated plaster should be removed and replaced using a suitable replastering specification. For compatible BPI system products, consider BPI Renovating Plaster or BPI Easy Mix Waterproofer & Plasticiser for Mortar & Render. In all cases, the damp proof course should, as far as practicable, be installed in accordance with BS 6576:2005, the Code of Practice for the installation of chemical damp proof courses. Special Features Ready-to-use silicone emulsion DPC cream Suitable for brick, stone and masonry walls For injection into mortar beds to help control rising damp Can be applied from inside or outside No high-pressure injection pump required Easy, fast and clean installation Virtually odourless Low hazard when used as directed 1 litre treats approximately 5 linear metres of a 230mm / 9-inch wall Tested to BBA MOAT No. 39:1988 Compatible with BPI waterproofing and replastering systems Specification Packaging and Size: 1 Litre Plastic Cartridge Colour: White Typical Coverage in 115mm / 4.5-inch wall: 10 linear metres Typical Coverage in 230mm / 9-inch wall: 5 linear metres Typical Coverage in 345mm / 13.5-inch wall: 3.3 linear metres approx. Typical Coverage in 460mm / 18-inch wall: 2.5 linear metres approx. Drill Hole Diameter: 12mm Hole Spacing: Maximum 120mm centres Storage: Store in cool, frost-free conditions Shelf Life: Use within 12 months Health & Safety: Refer to the BPI Safety Data Sheet before use. May cause skin irritation. Wear suitable protective gloves and eye protection when handling.